The RB-SM2 consists of two independent converters which will produce two fully buffered and balanced mono line outputs from two stereo inputs. All connections are on the rear panel.
The XLR-3 inputs are electronically balanced with an impedance of 20kohm bridging. These can be wired unbalanced to accept an output from domestic equipment.
The XLR-3 line outputs are electronically balanced with an output impedance of <50 ohm. The outputs can be wired unbalanced by grounding the non-phase signal, allowing you to feed balanced and unbalanced equipment.
Output gain adjustment using pre-set potentiometers for both converters allows a normalised mono output from domestic stereo equipment. The potentiometers are accessible through the rear panel.
Audio Specification Maximum Input Level +28dBu Maximum Output Level +28dBu Frequency Response 20Hz to 20kHz +/- 0.1dB (600 ohm load, ref 1kHz) Gain Range Adjustable 8dB loss to 18dB gain, ref. 0dBu in on L and R Common Mode Rejection >66dB typically Distortion THD @ 1kHz +8dBu 0.01% Noise -100dB unity gain ref +8dBu Input Impedance >20kohm balanced bridging Output Impedance <50ohm Connections Inputs 4 x XLR 3 pin female (balanced, can be unbalanced) Outputs 2 x XLR 3 pin male (balanced, can be unbalanced) Mains Input Filtered IEC, switchable 110-120V, or 220-240V, fused, 6W max Physical Specification Weight Nett: 1.05kg Gross: 1.5kg Dimensions Raw: 28cm (W) x 10.8cm (D) x 4.2cm (H) Boxed: 36cm (W) x 20.5cm (D) x 6cm (H)
- Review this product