Cart Overview

There are no items in your shopping cart

Sonifex RB-SL2

Twin Mono or Stereo, Limiter
1 option selected

(0 reviews)

A great Microphone Limiter for use in all demanding environments, from Commercial to community radio.

Product Options

RB-SL2 $408.00
RB-SL2 (115Volt version) $408.00
  • The RB-SL2 is a stereo, or twin independent mono, VCA limiter for use in news-rooms and other locations where the correct level into recording equipment is required, but not necessarily under the control of an engineer, for example, for overload protection. It can also be used as an inexpensive main output limiter for small scale radio stations, hospital radio and student radio.
    The XLR-3 electronically balanced inputs and outputs can be wired unbalanced to accept an output from domestic equipment.

    For each channel there is an input gain and a threshold level control. With the limit threshold set to maximum, the input through to output can be normalised using the input potentiometers. Once the unit is acting as a buffer with gain/attenuation, the limit threshold level can be set, with the recovery adjusted for the application. The power LED indicates limiting by flashing.

    The rear panel mode switch changes the unit from dual mono to stereo, when only the pre-sets for channel 1 (left) are active and apply to both channels. Stereo limiting operates by limiting both left and right outputs if either left or right input needs to be limited. Dual mono limiting operates by limiting left and right signals individually, so you can use the RB-SL2 as two separate mono limiters.

    Please the variant form the product options.

  •   Audio Specification
    Maximum Input Level +28dBu
    Maximum Output Level +28dBu
    Input Gain Adjustable -8dB to +18dB gain
    Limit Threshold Adjustable -8dBu to +28dBu gain
    Frequency Response 20Hz to 20kHz +/- 0.1dB (600 ohm load, ref 1kHz)
    Noise -100dB unity gain ref +8dBu
    Distortion 0.01% THD @ 1kHz, ref +8dBu output, threshold set at +10dBu
    Common Mode Rejection >66dB typically
    Input Impedance >20kohm balanced bridging
    Output Impedance <50 ohm
    Inputs 2 x XLR 3 pin female (balanced, can be unbalanced)
    Outputs 2 x XLR 3 pin male (balanced, can be unbalanced)
    Mains Input Filtered IEC, switchable 110-120V, or 220-240V, fused, 6W max
      Physical Specification
    Weight Nett: 1.0kg Gross: 1.45kg
    Dimensions Raw: 28cm (W) x 10.8cm (D) x 4.2cm (H) Boxed: 36cm (W) x 20.5cm (D) x 6cm (H)
      Equipment Type
      Code   Description Plug
    RB-SL2 UK Twin mono, or stereo limiter, 230V (UK 3 pin to IEC) UK
    RB-SL2 EU Twin mono, or stereo limiter, 230V (European Schuko 2 pin to IEC) EU
    RB-SL2 US Twin mono, or stereo limiter, 115V (USA 3 pin to IEC) US
    RB-SL2 AU Twin mono, or stereo limiter, 230V (Australasian 3 pin to IEC)
  • Review this product

    Please enter the characters shown in the image below:

Featured manufacturers

Please Wait